Escort Prism 20401 Dokumentacja Pobierz pdf (Strona 21)

1-10

1. External DC Input (12 - 28V) Connector

Allows an external DC power source to be connected for extended use during transport where AC

power is not available. Batteries are also charged with external DC power.

2. Fuse Holder and Fuse Replacement

The fuse holder contains the fuses for the monitor. Open the door of this holder to replace fuses.

It is recommended that qualified technical service personnel replace fuses when necessary.

WARNING: For protection against fire, replace the fuses only with

those of the same type and rating.

The Prism SE requires two identical slow blow T2.5A / 250V fuses for operation. Ensure that the

AC power cord has been disconnected before replacing fuses. Carefully open the door of the fuse

holder with a short 1/8" flat screwdriver. Replace the blown or defective fuse with one of the

same type and rating. Noting orientation, gently slide the fuse holder back until it locks snugly

into its original place. After the fuse replacement, connect the AC power cord to the Prism SE.

The unit is now ready for operation.

3. AC Power Cord Input Connector and Optional Power Cord Mounting Bracket

Allows connection of the AC power cord to the monitor. In addition, the AC power cord must be

plugged into an AC source before the monitor can operate on AC power and before the batteries

can be charged.

For permanent connection, the MDE power cord bracket should be installed. See the following

figure for instructions on installing the power cord mounting bracket.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 169 170

Brak uwag

Escort Prism 20401 Dokumentacja Strona 21